MA 10 - PTFE backed EPDM - SED Diaphragm

MMX

SED Diaphragms

The diaphragm is the most important component of the diaphragm valve. Besides the valve body, the diaphragm is the only part which contacts the process medium. It is the dynamic part with which the flow rate of the process medium is controlled and/or stopped.

PTFE diaphragms offer the highest degree of chemical resistance, increased stability, longer flex life, less porosity, reduced cold flow, and superior performance through temperature fluctuations between hot and cold and steam sterilization cycles.

The PTFE MA 10 consists of a seperate EPDM backing cushion and a PTFE diaphragm. It is designed as one-piece diaphragm: this means that the EPDM back is bonded with the PTFE. The diaphragm is always manufactured in the molded open position. These one-piece diaphragms have less surface area and are subject to shorter linear strokes. MA 10 diaphragm utilizes a threaded stud assembly with the valve operating mechanism. This eliminates the potential for point loading at the center of the diaphragm.

All diaphragms are clearly indentified and the material is batch traceable by a set of unique codes molded into the diaphragm dvary.

MA 10 is suitable for diaphragm valves: KMA 295, KMA 195, KMD 289, KMD 188, Steripur 397, Steripur 317
SED articlenumber: 00210.186.515.51 TF/EP

Technical Information

Sizes DN8 to DN20, IMP 3/8”- ¾”
Temp. range -20°C to 150°C
Connections Threaded stud
Material PTFE backed EPDM Diaphragm (bonded)
Certificates FDA, USP Class VI 121 ºC, {87}, {88}, TSE/BSE (ADCF), 3-A Sanitary Class II and III, Extractable organic substances (ISO 10993-18)
DOWNLOADS

pdfDatasheet SED Diaphragms
English - 832 kB - TD06 0018 rev. L